Tape & Film

It’s a urethane protective strip placed between material and tooling to prevent scuffs and witness marks during bending—ideal for cosmetic parts or sensitive finishes.

Carbon steel, aluminium, stainless steel and pre-painted sheet—useful anywhere surface finish matters.

Two thicknesses (0.4 mm and 0.6 mm) and two widths (90 mm and 150 mm), with roll lengths from 5 m to 100 m.

The small added thickness can slightly influence inside radius. We recommend accounting for the film gauge in your bend allowance or doing a quick trial bend.

Position the film centrally over the V-die, tension it across the bed, and feed fresh film as required. Keep the surface clean and free of swarf.

Yes—most applications are air bends; for bottoming/coining, verify tonnage and check the film condition more frequently.

Use is typically single-pass on critical surfaces. You can advance the roll to a fresh section to maintain mark-free results.

Material type/finish, sheet thickness range, part widths, expected quantity, and your preferred width/roll length.