Guillotine Breakdown, Repair
Metal Cutting Guillotine, Service, Breakdown, Repair.
Service, Breakdown, repair support is available for hydraulic and mechanical metal cutting guillotines, including Blade re-grind, or replacement cutting blades, calibration of back-gauge, NC Controller & back-gauge screw checked over, Oil & filter changes, emergency stop system, rear entry system checked.
JPS Machinery Ltd service team engineers can attend your site to assess any raised issues and carry out the required work to return your metal cutting guillotine to operation.
Breakdown repair support includes:
On-site fault diagnosis and troubleshooting
Hydraulic and Electrical fault identification
Backgauge system re- calibration, back gauge screw, replaced, general fault finding, maintenance
NC Controller check up, re calibrate etc
Blade inspection, blade gap adjustment, blade re-grind or replacement
Machine recalibration and setup following any repair or cutting blade change
Guillotine Service, Breakdown, Repairs Covered
Service, Breakdown,Repair support is available across a wide range of metal cutting guillotines Hydraulic, Mechanical DD, Swing Beam, Vertical Action, Variable Rake, NC or CNC controlled – The JPS Service Team are: ‘Experienced, Reliable, Professional’
Hydraulic Guillotines
Repair and fault diagnosis for hydraulic guillotines, including pressure issues, return system faults and cutting performance problems.
CNC Guillotines
Diagnosis and repair of CNC-controlled guillotines, including control faults, backgauge issues and parameter loss.
Mechanical Guillotines (Direct Drive)
Repair support for mechanical guillotines, including drive system faults and operational issues.
NC Guillotines
Repair and setup for NC guillotines, including calibration and positioning faults.
Common Guillotine Faults & Repairs
Service, fault diagnosis and repair support covers a wide range of issues affecting a metal cutting guillotine. i.e. cut length accuracy, cut quality, a deburr free cut edge, ongoing production reliability.
If a specific fault is not listed, further support is available to diagnose and resolve the issue.
Cutting & Blade Issues
- Worn, chipped or blunt guillotine blades
- Blade regrinding or New replacement cutting Blades
- Poor quality cuts, burred cut edge
Backgauge & Positioning Faults
- Backgauge misalignment and calibration issues
- Positioning errors affecting cut accuracy
- CNC/NC backgauge faults
Hydraulic System Issues
- Low viscosity hydraulic oil, needs changing, tank needs cleaning etc,
- Hydraulic leaks, cylinders might need re-sealing, hold downs leaking etc.
- Pump pressure loss
- Hydraulic valve failure
Mechanical Faults
- Drive system issues on mechanical guillotines
- Wear and failure of mechanical components
- General machine operation faults
Control System Faults
- CNC or NC control faults
- Loss of parameters due to battery failure or operator error
- Control system diagnostics and repair
Additional Repairs
- Guillotine return spring issues (including re-gassing)
- General servicing and adjustment following repair
Guillotine Manufacturers Supported
Repair support is available for a wide range of press brake manufacturers, including:
- RICO
- TECHNA-FAB
- LVD
- AMADA
- HACO
- DURMAZLAR
- EDWARDS PEARSON
- ERMAKSAN
- CIDAN
- MORGAN RUSHWORTH
Call: 0113 236 3366
