SICMI PCL – C-Frame Hydraulic Stamping Press

The movable upper surface has 2 self-lubricating guides as standard for models up to 200 tons and 4 guides for higher tonnages and is also equipped with T-slots for fixing the moulds.
The lower table is instead bolted to the frame and is also equipped with T-slots.

The PCL electro-hydraulic press is supplied in models starting from 40 tons up to 300 tons and is available both in the semi-automatic version and with automatic operation.

Semi-automatic version
This system works with the simultaneous use of the lever and the ignition button and is equipped with rod end stroke sensors, which regulate the ascent and descent of the cylinder.

Automatic version
This C-frame hydraulic stamping press in automatic mode is operated through the simultaneous use of double buttons and is also equipped in this case with cylinder limit switches. The rising of the work surface is automatic.
This version also includes the installation of the Siemens PLC and Rexroth solenoid valves.
The PCL workshop hydraulic press is also equipped with a mobile push-button panel mounted on a pedestal on which all the main commands for the operation of the press are installed.

Accessories:
– 4 self-lubricating sliding guides for models up to 200 tons.
– Sliding lateral metal protection grilles with safety sensors
– Hydraulic cushion from 20 to 80 tons

Accessories (only for automatic version):
– Front light barriers
– Digital control with Siemens display
– Digital control of the blank holder cushion
– Timer
– Piece counter
– Air/oil heat exchanger with decompression valve
– Decompression
– Pressure switch