• Get in touch today 0113 2363366

Repair / Breakdown of a Press Brake

Typical repair breakdown faults are:

Operator guards not working

Rear fence interlocks mis aligned
condition of tooling & tooling clamping systems

Bend angle incorrect

Check infra red or Laser operator guards alignment

Press brake not going through its start up safety checks

Machine motor does not start

Check emergency stop buttons, check side & rear interlocks

Leaking hydraulic cylinders requiring the seals replacing

Low hydraulic pressure often caused by high oil temperature, or old oil low viscosity

Hydraulic filters in need of cleaning or changing

Faulty Hydraulic pump motor the motor nipple has not been used as recommended by the motor manufacturer

Electrical faults such as sticking contactors